The Use of Additive Technologies in the Study of the Process of Cross Wedge Rolling Workpiece for the Stamping of the Crankshaft

This paper describes the experimental study and modeling of the process of cross wedge rolling workpiece for the stamping of the crankshaft using a tool printed on a 3D printer. The study shows the design and printing features of the tool for cross wedge rolling. A comparison of the experiment and simulation in Qform program. © 2022 Trans Tech Publications Ltd, Switzerland.

Авторы
Allenov M.G.1 , Allenov D.G. 2 , Belokurov O.A.1 , Hasanov B.D. 2
Сборник материалов конференции
Key Engineering Materials
Издательство
Trans Tech Publications Ltd
Язык
Английский
Страницы
259-264
Статус
Опубликовано
DOI
10.4028/P-K2SJ1N
Том
910 KEM
Год
2022
Организации
  • 1 BMSTU, Engineering Technology Department, 105005 Baumanskaya 2-ya str. 5, Moscow, Russian Federation
  • 2 RUDN University, Engineering academy, 117198 Miklukho-Maklaya str. 6, Moscow, Russian Federation
Ключевые слова
additive technologies; cross-wedge rolling; forging and stamping; modeling of stamping
Цитировать
ГОСТ MLA RIS BibTex
Поделиться

Другие записи