DEFORMATION OF A HOLE MACHINED BY A MANDREL Article Rogov V.A., Koshelenko A.S., Zhed' O.V. Russian Engineering Research. Vol. 33. 2013. P. 289-294
STRESS CONCENTRATION IN PLANE OPTICAL MODELS OF ROUND BROACHES Article Rogov V.A., Koshelenko A.S., Zhed' O.V., Predeina A.I. Russian Engineering Research. Vol. 33. 2013. P. 416-421
MONITORING AND DIAGNOSTICS OF PIPE COMPONENTS Article Rastorguev G.A. Russian Engineering Research. Vol. 32. 2012. P. 539-543
SURFACE LAYER OF QUARTZ-BASED WEAR-RESISTANT STRUCTURAL CERAMIC AFTER MACHINING Article Rogov V.A., Shkarupa M.I. Russian Engineering Research. Vol. 31. 2011. P. 302-306
STRESS-STRAIN STATE OF CUTTING-PLATE SUPPORTS Article Rogov V.A., Koshelenko A.S., Popikov A.N. Russian Engineering Research. Vol. 31. 2011. P. 383-386
DAMPING PROPERTIES OF REAMING LATHE CUTTERS WITH INSERTS OF DENSE CMPOSITE Article Rogov V.A., Belov P.S. Russian Engineering Research. Vol. 31. 2011. P. 570-573
DIAGNOSTICS OF AN AXIAL CUTTING TOOL ON THE BASIS OF THE GAS CONCENTRATION IN THE CUTTING ZONE Article Afanas'ev K.V., Rogov V.A. Russian Engineering Research. Vol. 31. 2011. P. 1262-1265
AUTOMATED CALCULATION OF OPTIMAL CUTTING CONDITIONS FOR LOW-TEMPERATURE STEEL Article Rogov V.A., Fomin E.V., Fomin A.V. Russian Engineering Research. Vol. 30. 2010.
OPTIMIZING THE CUTTING OF LOW-TEMPERATURE STEEL BY SIMULATION Article Rogov V.A., Fomin E.V., Fomin A.V. Russian Engineering Research. Vol. 30. 2010. P. 702-704
ADAPTIVE CONTROL SYSTEM FOR A TOOL DRIVE IN MACHINING Article Korolev D.A., Romashin V.G., Shadrin A.P., Nepovinnykh O.V., Rogov V.A. Russian Engineering Research. Vol. 30. 2010. P. 906-909
EFFECTIVENESS OF WEAR-RESISTANT TIN AND (TIZR)N COATINGS IN FACE MILLING OF LOW-TEMPERATURE STEEL Article Rogov V.A., Fomin E.V., Fomin A.V. Russian Engineering Research. Vol. 30. 2010. P. 1180-1181
STRESS FIELDS IN THE SURFACE LAYER OF COMPOSITES WITH SPHERICAL REINFORCING GRAINS ON CUTTING Article Semenov I.A., Rastorguev G.A. Russian Engineering Research. Vol. 29. 2009. P. 264-267