In concrete mixing plan, we usually encounter a combination of aggregates including sand, the amount of cement, which is actually the criterion of concrete grade, and the volume of water consumed. Changes in the quality and quantity of these components actually create the usual types of concrete. But the attitude that formed the basis of this research is based on the change in the nature of the components of the concrete mixing design. Removal of water and cement from the mixing plan and replacement of polymeric materials as well as the use of mixed LECA aggregates instead of aggregates is the basis of this research. In this paper, by examining and selecting LECA grain style and pre-treatment (hydrophobicity and coupling), in a constant ratio of resin, concrete samples were selected from three dimensional categories. After making the samples, flexural strength test was performed on them and the results were analyzed. Various compounds and processes have so far been proposed in the lightweight concrete mixing scheme. The distinctive point of this study is the use of lightweight expanded clay concrete with heat-treated acrylic polymer (crosslinking constituents) and related coupling agents. It is also important to select and apply the right amount of hydrophobic nanoparticles for hydrophilic surface hydrophobicity. Hydrophobicity was possible due to the non-polar nature of the acrylic polymer and the use of hydrophobic nanomaterials.
В процессе бетоносмешения обычно используется комбинация заполнителей, включающая песок, некоторое количество цемента, являющегося критерием качества бетона, и объем потребляемой воды. Изменения качества и количества этих компонентов фактически создают традиционные типы бетона. Настоящее исследование основано на изменении характера компонентов конструкции бетоносмешения. В его основе удаление воды и цемента из плана смешивания и замена их полимерными материалами, а также использование смешанных заполнителей типа LECA. Путем изучения и выбора типа зерна LECA и предварительной обработки (гидрофобность и сцепление) в постоянном соотношении полимера были отобраны образцы бетона из трехмерных категорий. После изготовления образцов на них проводились испытания на прочность при изгибе и анализировались полученные результаты. Ранее в схеме смешивания легких бетонов предлагались различные вариации соединения и процессов. Отличительная особенность данной работы заключается в использовании легкого керамзитобетона термообработанным акриловым полимером, скрепляющим компоненты, и сопутствующими связующими веществами. Особое внимание уделено выбору и нанесению нужного количества гидрофобных наночастиц для достижения гидрофобности прежде гидрофильной поверхности. Гидрофобность стала возможной благодаря неполярной природе акрилового полимера и использованию гидрофобных наноматериалов.