Possibility of ABS polymers application for centrifugal wheel model manufacture by additive printing

This research is dedicated to an investigation of sample’s strength properties from different ABS polymers, produced using additive technology, because of it benefits in details manufacture less than 35 MPa load. Centrifugal wheel models are examples of such details, which could be used, when units for gas pumping in the petrochemical and oil refining industries are tested. The research of samples, produced by additive printing from ABS Carbon, ABS Plus1 (with titanium nitride impurities), ABS Plus 2 (unpainted), was performed. Polymers, manufactured by this technology, have anisotropic properties. In this investigation the sample’s strength properties along the fiber were defined. © 2019 American Institute of Physics Inc.. All rights reserved.

Authors
Volkov-Muzylev V.V.1 , Vendland L.E. 1, 2 , Borisov Yu.А.1, 3 , Demidov A.N.4
Conference proceedings
AIP Conference Proceedings
Language
English
Status
Published
DOI
10.1063/1.5122120
Number
040001
Volume
2141
Year
2019
Organizations
  • 1 Joint Institute for High Temperatures of RAS, 13/2, Izhorskaya Str., Moscow, 125412, Russian Federation
  • 2 RUDN University, 6, Miklukho-Maklaya Str., Moscow, 117198, Russian Federation
  • 3 Bauman Moscow State Technical University, 5/1, 2nd Baumanskaya Str., Moscow, 105005, Russian Federation
  • 4 Moscow Power Engineering Institute, 14, Krasnokazarmennaya Str., Moscow, 111250, Russian Federation
Date of creation
24.12.2019
Date of change
24.12.2019
Short link
https://repository.rudn.ru/en/records/article/record/55088/
Share

Other records