Effect of basalt fibres on the parameters of fracture mechanics of MB modifier based high-strength concrete

Basalt fibres (BF) are increasingly studied in structural applications due to its environmental friendliness and good mechanical properties. Mass production of high-strength concrete (HSC) in Russia is mainly associated with the use of organomineral modifiers of the MB series, containing in their composition microsilica, fly ash, hardening regulator and superplasticizer C-3 in different ratios. In our study we produced HSC specimens (without BF, and with 1 wt.% chopped BF) using the modifier MB10-30, with the dimensions of 100x100x100 mm, 100x100x400 mm, 100x100x400 mm with the artificial crack of 25 mm deep in the middle of the span, and also 100x75x400 mm (75 mm height was taken equal to the height of the section above the crack of the 2nd type of prisms). The compressive strength, the tensile strength at bending, the strength at axial tension, the cracking moment, and also the parameters of fracture mechanics, such as: the critical stress intensity factor and the critical energy release rate, at the curing periods of 7, 14, 28, 60 days, have been determined. We also evaluated the influence of crack in the bend element on the value of the cracking moment. The results showed that the inclusion of BF in MB modifier based HSC resulted in a decrease in the compressive strength, however, significantly enhanced its flexure behavior. © The Authors, published by EDP Sciences, 2018.