В статье рассматриваются вопросы формирования в Автокаде нормальных циклических поверхностей и в плоскостях пучка. Показано, что образование поверхностей целесообразно выполнять на основе их отсеков. Разработан алгоритм образования циклических поверхностей, приведены фрагменты программ по реализации предложенного алгоритма
The possibility of the formation of the normal cyclic surfaces and cyclic surfaces in planes of the pencil in AutoCad is discussed in the article. It is shown that the formation of surfaces should be performed on the basis of their compartments. The algorithm of formation of cyclic surfaces, the fragments of programs for the performance of the proposed algorithm are given