Improving Precision in Selective Assembly

Abstract: A method is proposed for calculating the limiting deviation and group tolerances when group interchangeability (selective assembly) is used. The example considered is increase in precision of the gap in the joint between a hydraulic cylinder and the piston rod. © 2019, Allerton Press, Inc.

Авторы
Timiryazev V.A. 1 , Khostikoev M.Z.2 , Konoplev V.N. 3 , Nabatnikov Y.F.4 , Mnatsakanyan V.U.4
Журнал
Russian Engineering Research
Номер выпуска
6
Язык
Английский
Страницы
499-502
Статус
Опубликовано
Ссылка
Внешняя ссылка
DOI
10.3103/S1068798X19060182
Том
39
Год
2019
Организации
  • 1 Stankin Moscow State Technical University, Moscow, Russian Federation
  • 2 Gubkin Russian State University of Oil and Gas, Moscow, Russian Federation
  • 3 Engineering Academy, Peoples’ Friendship University of Russia, Moscow, Russian Federation
  • 4 Mining Institute, Moscow Institute of Steel and Alloys, Moscow, Russian Federation
Ключевые слова
closing term; dimensional chain; group interchangeability; group tolerances; selective assembly
Цитировать
ГОСТ MLA RIS BibTex
Поделиться

Другие записи