Монография посвящена повышению эффективности формообразующего инструмента, изготавливаемого из наиболее применяемых инструментальных материалов: быстрорежущих сталей и твердых сплавов.Для инструментов из быстрорежущих сталей выполнена сравнительная оценка стандартов промышленно развитых стран и Российской Федерации. Приводится характеристика эксплуатационных и технологических свойств. Рекомендованы быстрорежущие стали и технологии, позволяющие повысить эффективность инструмента. Даны рекомендации по видам инструментов.Проанализированы свойства твердых сплавов и области их рационального применения. Рассмотрены конструкционные материалы сборного и паяного инструмента. Даны рекомендации по выбору твердых сплавов, показаны направления создания новых композиций твердых сплавов для повышения эффективности инструмента при обработке труднообрабатываемых жаропрочных сталей и сплавов.Предназначена для инженерно-технических и научных работников металлургической и обрабатывающей отраслей промышленности. Может быть использована при подготовке магистров, аспирантов технологических университетов.
The monograph is devoted to improving the efficiency of forming tools made from the most used tool materials: high-speed steels and hard alloys.For tools made of high-speed steels, a comparative assessment of the standards of industrially developed countries and the Russian Federation was carried out. The characteristic of operational and technological properties is given. High-speed steels and technologies are recommended to increase the efficiency of the tool. Recommendations on the types of tools are given.The properties of hard alloys and the areas of their rational application are analyzed. The structural materials of prefabricated and soldered tools are considered. Recommendations on the choice of hard alloys are given, directions for the creation of new compositions of hard alloys to increase the efficiency of the tool in the processing of hard-to-process heat-resistant steels and alloys are shown.It is intended for engineering, technical and scientific workers of the metallurgical and manufacturing industries. It can be used in the preparation of masters, postgraduates of technological universities.